Class A RV Cover Installation Guide

This guide provides a detailed overview of what is included with your Class A RV Cover. pre-installation requirements, step-by-step installation and removal instructions, cleaning guidelines, and answers to common questions. Contents

1. Package Contents

2. Pre-Installation Requirements

3. Installation Procedure

4. Removal Procedure

5. Cleaning Guidelines

6. Frequently Asked Questions (FAQs)

Package Contents

● 1 x Class A RV Cover
● 1 x Storage Bag
● 4 x Rain Gutter Protectors
● 1 x Ladder Cap
● 1 x Repair Patch
● 1 x Weighted Buckles Bag

Pre-Installation Requirements

● Clean the RV: Ensure your RV is thoroughly cleaned to prevent debris from damaging the cover and to prolong its lifespan.

● Pad Sharp Edges: Identify and pad any sharp edges such as mirrors, gutters, or awnings to avoid tearing the cover. Use the provided rain gutter protectors and ladder cap.

Installation Procedure

1. Prepare the Cover - Unpack the cover on a clean, flat surface and undo any straps or buckles.

2. Position the Cover - Lay the cover flat with the roof section facing up. Identify the front by locating the "FRONT" tag inside the cover.

3. Fold and Roll - Fold the sides of the cover toward the center and roll from the back to the front.

4. Move the Cover to the Roof - Place the rolled cover on the RV roof at the front. Assistance may be required for this step.

5. Unroll and Drape - Unroll the cover toward the back, allowing the sides to drape down.

6. Adjust the Cover - Ensure the cover is properly aligned and secure the bottom corner straps. Adjust the remaining straps to secure the cover fully. Removal Procedure To remove the cover, reverse the installation steps:

1. Unfasten all straps.
2. Roll the cover from back to front.
3. Fold it neatly and store it in the provided storage bag.

Important: Ensure the cover is dry before storing to avoid mildew damage. Cleaning Guidelines

● Manual Cleaning Only: Install the cover and rinse with water. Use a cloth and multi-purpose cleaner for stubborn areas.

● Rinse and Dry: Thoroughly rinse the cover and let it air dry or wipe with a towel.

Do Not:

● Use soap, bleach, fabric softeners, or ironing.

● Store the cover while wet.

6. Frequently Asked Questions (FAQs)

How do I measure my Class A RV?

● Length: Measure from the front bumper to the rear, including any ladders or spare tires.

● Height: Measure from the highest point of the sidewall to the frame, excluding accessories.

How can I identify the front of the cover?

● Look for the "FRONT" tag inside the cover.

What are the zippers on the cover for?

● The zippers provide access to the RV while covered.

How do I install the ladder cap?

● Place the ladder cap over the ladder and secure it with Velcro straps.
How do I use the weighted buckle bag?

● Attach the buckle to the strap, fill the bag with rocks or sand, and toss it under the RV for easy securing.