Destination Trailer Cover Installation Guide

• Clean your RV

• Protect sharp edges

• Lay the cover flat on the ground. Unclip any straps

• Locate the “Front” tag to determine the front of the cover

• Lay the cover on the ground lengthwise, inside out with the exterior facing up

• Fold the sides inward, then roll from back to front

• Lift the rolled cover onto the roof

• Start at the front and begin unrolling it towards the back, letting the sides hang down

• Pull the cover down into place

• Walk around the RV and adjust fit as needed

• Secure straps starting with the front and the rear

• Fill toss bag with rocks/sand to weight it and use to toss straps under the RV

• Use weighted toss bag to also secure extra-long straps around entire RV

Removal :

• Consider cleaning the cover while it is still in place (see cleaning tips below)

• Unfasten all straps

• Lift the front of the cover onto the roof of the RV

• From the rear, pull the cover down and off

Care/Cleaning:

• For optimal results, clean the cover while it’s still on your RV—this makes dirt easier to spot and helps the cover dry more efficiently

• Simply hose down the cover and let it dry completely

• Spot wash stubborn stains using warm water and mild detergent

• Check the cover for any damage, such as tears, holes, or loose seams. The included adhesive patch kit makes quick repairs easy

** Do Not use soap, bleach, fabric softeners, or iron the cover

** Do Not store the cover while it is wet