Travel Trailer Cover Installation Guide

This guide provides detailed instructions on how to install, remove, and care for your Travel Trailer RV cover. It includes a pre-installation checklist, step-by-step instructions, cleaning guidance, and answers to frequently asked questions. Contents

1. Package Contents

2. Pre-Installation Requirements

3. Installation Procedure

4. Removal Procedure

5. Cleaning Guidelines

6. Frequently Asked Questions (FAQs)

Package Contents

● 1 x Travel Trailer RV Cover

● 1 x Storage Bag

● 4 x Rain Gutter Protectors

● 1 x Ladder Cap

● 1 x Repair Patch

● 1 x Weighted Buckles Bag

Pre-Installation Requirements

● Clean the Trailer: Ensure your travel trailer is free from dirt, debris, and moisture to prevent damage and extend the lifespan of the cover.

● Inspect for Sharp Edges: Identify any sharp areas like mirrors, gutters, or awnings that could damage the cover. Use the provided rain gutter protectors and ladder cap to shield these vulnerable areas.

Installation Procedure
1. Prepare the Cover - Lay the cover on a clean, flat surface (e.g., driveway or lawn). Unfasten all buckles or straps.

2. Position the Cover - Lay the cover flat with the roof section facing upwards. Locate the tag marked "FRONT" to identify the front of the cover.

3. Fold and Roll - Fold the sides of the cover toward the center of the roof section and roll it from the back to the front.

4. Move the Cover to the Roof - Lift the rolled cover to the roof of your trailer, starting at the front. Assistance may be needed depending on the trailer's size.

5. Unroll and Drape - Unroll the cover towards the back of the trailer, allowing the sides to drape over the edges.

6. Secure the Ladder Cap - As you descend, install the ladder cap to prevent tearing. Pull the cover down over the sides of the trailer.

7. Adjust the Cover - Before securing the bottom straps, ensure the cover is centered on the trailer.

8. Fasten the Straps - Start by securing the bottom corner straps, then fasten the middle and bottom straps. Use the weighted buckle bag to toss the straps under the trailer for easy fastening.

9. Final Check - Verify that the cover is properly fitted, adjusted, and all straps are secured. Warnings

● Do not occupy the trailer while the cover is on.

● Do not run the engine while the cover is installed.

● Avoid installing the cover in windy or slippery conditions.

● Always have two people assist with installation for safety.
Removal Procedure

To remove the Travel Trailer RV Cover, reverse the installation steps:

1. Unfasten all straps.

2. Roll the cover from back to front.

3. Fold it neatly and store it in the provided storage bag.

Important: Ensure the cover is dry before storing to avoid mildew damage.

Cleaning Guidelines

● Manual Cleaning Only: Install the cover on the trailer and use a hose to remove dirt and debris. For stubborn spots, use a cloth with a mild multi-purpose cleaner.

● Rinse and Dry: After cleaning, rinse thoroughly and allow the cover to air-dry or use a towel to speed up drying.

Do Not:

● Use soap, bleach, or fabric softener.

● Use an iron on the cover.

● Store the cover while wet.

6. Frequently Asked Questions (FAQs)

How do I measure my Travel Trailer?

● Length: Measure from the front to the rear, including bumpers, spare tires, and ladders. Do not include the hitch and tongue.

● Height: Measure from the top of the roofline to the bottom of the frame, excluding ground clearance and roof-mounted accessories.

How can I identify the front of the cover?

● The cover has a white tag labeled "FRONT" to indicate the front section. In case the tag is missing, the same section will still be considered the front.

What are the vertical zippers for?

● The zippers are designed to provide access to the trailer while covered. Some models also include a rear zipper for additional access.

How do I install the ladder cap?

● Place the ladder cap over the ladder and secure it using the Velcro straps. This prevents damage to the cover from sharp edges.

How do I use the weighted buckle bag?

● Attach the buckle to the strap, fill the bag with rocks or sand, and use it to toss the straps under the RV for easy fastening.

How do I install the rain gutter protectors?

● Attach the protectors over the rain gutters and secure them with Velcro to prevent damage to the cover.